linux - 在 Linux 上安装 Sybase ASE

Question

全部，

我正在尝试在我的 Gentoo Linux 机器上安装 Sybase ASE Developer Edition。

我下载了最新版本的 ASE (16.02)，将其解压缩并尝试运行 GUI 安装程序。结果如下:

IgorReinCloud ASE_Suite # ./setup.bin  Preparing to install...
Extracting the JRE from the installer archive... Unpacking the JRE...
Extracting the installation resources from the installer archive...
Configuring the installer for this system's environment...

Launching installer...

No protocol specified

Graphical installers are not supported by the VM. The console mode
will be used instead...

===============================================================================
SAP Adaptive Server Enterprise                   (created with
InstallAnywhere)
-------------------------------------------------------------------------------

Preparing CONSOLE Mode Installation...

===============================================================================
Introduction
------------

InstallAnywhere will guide you through the installation of SAP
Adaptive Server  Enterprise 16.0 SP02 PL02.

It is strongly recommended that you quit all programs before
continuing with  this installation.

Respond to each prompt to proceed to the next step in the
installation.  If you want to change something on a previous step,
type 'back'.

You may cancel this installation at any time by typing 'quit'.

PRESS <ENTER> TO CONTINUE: quit

自从我运行 X + GNOME 3 后，我感到很惊讶。所以我试图检查安装日志文件。以下是摘录:

====================STDERR ENTRIES==================

GUI mode is not supported : Can't connect to X11 window server using ':0' as the value of the DISPLAY variable; you may consider checking your DISPLAY environment variable.
__________________________________________________________________________

所以，接下来我检查了 DISPLAY 变量:

IgorReinCloud log # set | grep -i display
DISPLAY=:0

我错过了什么？ DISPLAY 变量应包含什么值才能使安装成功？我有一台只有一个显示器/显示器的笔记本电脑(没有连接第二个)。

谢谢。

Answer 1

尝试通过以下方式配置您的 DISPLAY 环境变量:export DISPLAY=ip_address:0.0 with ip_address = 你可以用“ifconfig -a”找到的IP地址